HOW I BUILT A
 
 
BRIDGE
 
 
Courtesy of "Pete's Pond Page"
 
 
by Pete Orelup
 
pond, pond supplies, watergarden supplies, ponds, pond accessories, watergarden accessories, build pond, build watergarden, create pond, create watergarden, pond liners, pond fountains, pond kits, pond pumps, pond filters, waterfalls, waterfall filters, bridges, statuary, gardening, create paradise
 

For the "skeleton" I used 3 2"x6" redwood beams, each about 5' long. These run in parallel along the length of the bridge. Each is cut so that the top surface curves slightly. I was able to make this cut with a skill saw since the curve is very gradual. From the side, each beam looks like this:

 
pond, pond supplies, watergarden supplies, ponds, pond accessories, watergarden accessories, build pond, build watergarden, create pond, create watergarden, pond liners, pond fountains, pond kits, pond pumps, pond filters, waterfalls, waterfall filters, bridges, statuary, gardening, create paradise
 
Redwood 2"x4" braces are placed between the beams, perpendicular to them. Each brace is about 1' in length. From above, the completed skeleton would look like this:
 
pond, pond supplies, watergarden supplies, ponds, pond accessories, watergarden accessories, build pond, build watergarden, create pond, create watergarden, pond liners, pond fountains, pond kits, pond pumps, pond filters, waterfalls, waterfall filters, bridges, statuary, gardening, create paradise
 
I used redwood 1"x3" stock for the slats that cover the skeleton. Each slat extends about 2-3" beyond the outer beams and is fastened to each of the three beams with finish nails. I spaced the slats about 1/4" apart.
 

I then attached small redwood blocks, 5 along each side, to serve as supports for the rails. The blocks are cubes about 1" on a side. The blocks are attached to the slats directly above where the slats are attached to the outer beams. I spaced the blocks evenly along the length of the bridge.

The rails, made from the same 1"x3" redwood used for the slats, are then attached to the tops of the blocks, and bent into a curved shape as they are screwed in place. This is probably the only tricky assembly step, since you have to be careful not to break the rails as you bend them into place. I used clamps to slowly bend the rails, screwing and gluing them to the blocks as I went. I used a waterproof wood glue to attach the blocks to the slats and the rails to the blocks, as well as 2" deck screws that extend through the rail, through the block, and into the slat.
I then gave the whole thing two coats of a semitransparent gray deck stain. You could also just leave it unfinished since it's redwood, but I wanted it to last longer so I used the stain.
 
pond, pond supplies, watergarden supplies, ponds, pond accessories, watergarden accessories, build pond, build watergarden, create pond, create watergarden, pond liners, pond fountains, pond kits, pond pumps, pond filters, waterfalls, waterfall filters, bridges, statuary, gardening, create paradise
 

The finished bridge was installed over the stream:

 
Courtesy of "Pete's Pond Page"
Pete Orelup
 
This design is easy to build, but perhaps you would rather purchase a bridge. SO, check out our BRIDGES. You will find several outstanding models to chose from and we have the ability to custom build these bridges to your specifications.
 
 
 
Everything you need to make your dreams come true !
BUILD YOUR OWN WATER GARDEN PARADISE
Secure on-line ordering with Visa or Mastercard
 
 
Looking for a specific item ? Search our website.
 

© 2000, 2001, 2002 Pond-A-Rama

Website
Questions or Problems - webmaster@pondarama.com